Pallmann PALL-X POWER Waterborne Floor Finish, Satin, 1 Gal (#81646)

WATERBASE · SATIN · 1 GAL

Pallmann PALL-X POWER is a single-component waterborne floor finish that Pallmann says delivers full two-component performance, for residential or high-wear commercial floors. It goes on milky and dries clear. This is the Satin sheen (22 gloss units) in a 1-gallon container.

• Type: Single-component waterborne finish
• Sheen: Satin, 22 GU (line: Ultra-Matte, Satin, Semi-Gloss, Gloss)
• Coverage: About 450–500 sq ft per gallon
• System: 1 coat of Pallmann sealer plus 2 coats of finish
• Dry time: Walk across in about 2–3 hours; abrade in 3–4 hours
• Cure: Full cure after about 4 days
• Sanding between coats: 120–180 grit screens or strips; never finer than 180
• VOC: Under 200 g/L
• Application: T-bar, brush, cut-in pad or waterborne roller; do not thin; apply at 65–75°F

Specifications from the Pallmann PALL-X POWER product page.

Pallmann PALL-X POWER Satin: common questions

Where can I buy Pallmann PALL-X POWER Satin near Atlanta or Nashville?

NDM Floors Distributor carries Pallmann PALL-X POWER Satin at our three stores: Stockbridge, GA (south metro Atlanta, 470-507-0711), Marietta, GA (north metro Atlanta, 770-627-4313) and Brentwood, TN (Nashville area, 629-216-1555). Stock varies by store, so call ahead to confirm availability and get a quote.

Does Pallmann PALL-X POWER need a hardener?

No. Pallmann PALL-X POWER is a single-component waterborne finish; Pallmann says its resin technology gives full two-component performance without a hardener.

How long does Pallmann PALL-X POWER take to dry?

Pallmann PALL-X POWER can be walked on in about 2–3 hours and abraded between coats after 3–4 hours. Full cure takes about 4 days.

How many coats of Pallmann PALL-X POWER do I need?

Pallmann specifies 1 coat of a Pallmann sealer followed by 2 coats of PALL-X POWER. Sand between coats with 120–180 grit, never finer than 180.

How much does a gallon of Pallmann PALL-X POWER cover?

One gallon of Pallmann PALL-X POWER covers about 450–500 sq ft per coat, applied with a T-bar, brush, cut-in pad or waterborne roller.

See more water-based floor finishes at NDM Floors Distributor.